Waterway Executive 56-Frame wet end

This Waterway Executive wet end is complete (yes, the seal and impeller are inside), and just needs to be connected to a motor. It is compatible with the various 56-Frame motors used in the Waterway Executive Euro range, both single-speed and two-speed. We also offer a 48-Frame wet end, which fits slightly smaller motors.

The wet end comes in a choice of four different impellers, named 2 HP, 3 HP, 4 HP and 5 HP. The numbers are confusing, because they do not match the power of the pump motor, which generally have lower powers than the impeller names suggest. To choose the right model, look for a reference on your old wet end or impeller, not on the motor. If in doubt, we recommend the 3 HP version for a motor under 1500W, 4 HP for a motor between 1500 and 1800W, and 5 HP for a motor over 1800W. If you're still in doubt, feel free to contact us.

Dimensions
Width: 204 mm
Height: 214 mm
Distance between connecting bolts on rear: 147 mm diagonal, 104 mm orthogonal, making this wet end compatible with 56-Frame motors (single-speed or two-speed).

Pipe connections
Discharge: screw thread with an outside diameter of 78 mm
Suction: screw thread with an outside diameter of 78 mm or 94 mm
This wet end will typically connect to a 2 inch pipe.

Waterway part numbers
Complete wet end: 310-1720 (2HP), 310-1730 (3HP), 310-1740 or 310-6970-SL (4HP), 310-1750 (5HP), 310-1440, 310-1480, 310-1500 ou 310-1510
Volute: 315-1220 (if you find this code on the back of your current wet end then you have definitely found the right part!)
Faceplate: 311-1220 (78 mm) or 311-1210 (94 mm)
Impeller: 310-4180 (5HP), 310-4190 (4HP), 310-4200 (3HP), 310-4210 (2HP)
Wet end seal: 319-3100B
All these parts are also available separately